Usi CSL2700 Especificações descarregar pdf (Página 20)

STEP 11:

To install a new roller or replace the original roller, reverse the removal procedure. Be sure to properly reposition

the sprockets and align the chain. All three sprockets should be in line with each other. Since the motor sprocket

was not removed, use it as a guide for alignment of the pull roll and laminating roll sprockets.

• The pull rollers on this laminator are interchangeable

with the laminating rollers. If the laminating rollers have

minor damage, each can be replaced by pull rollers. If

the laminating rollers are too badly damaged, they must

be replaced. The condition of the laminating rollers is

very important for a good lamination.

• If the chain feels too loose, it may be tightened as follows:

Loosen the motor mounting screws. Push down on the

motor sprocket and refasten the motor mounting screws.

Photo 20-2.

NOTE: Be sure to adjust the pressure on both pressure adjusting screws. 2-3 threads should show through the

adjusting screw mounting bracket. See page 21.

Photo 20-1

Photo 20-2

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Sem comentários

Usi CSL2700 Especificações Página 20