Usi CSL2700 Especificações descarregar pdf (Página 18)

REMOVING THE RUBBER ROLLERS

NOTE: Only remove rollers if they are cut or in poor

condition.

NOTE: The following procedure removes all 4 rollers.

In certain instances, it is not necessary to remove all 4 rollers,

therefore, remove as required.

STEP 1:

Remove all film from laminator. Photo 18-1.

STEP 2:

Unplug laminator. Make sure it is cool.

STEP 3:

Remove the thermometer and heat knob from the left side

of laminator. Remove the side housing on both sides of the laminator.

STEP 4:

Remove the top heat shoe. Photo 18-2.

Refer to diagram and instructions on page 16.

STEP 5:

Unfasten and remove the pressure adjusting screws on

both sides of the laminator. Photos 18-3, 18-4.

STEP 6:

Loosen the Allen head set screws on the left and right ends

of the top rubber rollers. Photo 18-5.

Photo 18-1

Photo 18-2

Photo 18-3

Photo 18-4 Photo 18-5

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Sem comentários

Usi CSL2700 Especificações Página 18